How to Make a Plastic Bottle Mosquito Trap
How to Make a Plastic Bottle Mosquito Trap
You can easily reduce the number of mosquitoes on your property with a plastic bottle trap that will attract and kill the mosquitos. The liquid in each trap will last about two weeks, and then, it can be easily replaced.[1]
X
Research source




For increased effectiveness, place multiple traps around your house or property.
Steps

Preparing the Trap Materials

Gather your materials. You will all of the items below to make a plastic bottle mosquito trap. Every item is easily found at your local grocery and hardware store. An empty, plastic 2 liter bottle A marker or pen A box cutter A tape measure 1/4 cup brown sugar 1-1 1/3 cup hot water 1 gram of yeast Measuring cup Tape (duct, scotch, or electrical are fine)

Make a mark halfway down the plastic bottle. About 4 inches (10 cm) from the lid of the 2 liter bottle is about half of the bottle. You can use a ruler or measuring tape to find where 4 inches down the bottle is. Extend the tape measure 4 inches. Hold the end of the tape up to the end of the bottle’s lid. Using your pen, make a mark where the tape measure ends; this is 4 inches.

Draw a circle around the bottle 4 inches from the lid. You will be cutting the plastic bottle in half. The measurements here do not need to be exact, but drawing a marked guide line will be helpful. Using the pen mark you just drew as a guide, draw a circle around the bottle 4 inches down from the lid. This will guide you in cutting the bottle in half.

Cut the plastic bottle in half. Cut carefully along your marked guide line until the bottle is in two sections. Keep both parts of the bottle; you'll use them both to make the trap. Be careful of sharp plastic edges as you cut. The edges don’t have to be perfect, so don’t worry if you’re a bit off from the marked guide line.

Assembling the Mosquito Trap

Pour 1-1 1/3 cups of hot water into the lower half of the bottle. Pour the water slowly; since it is hot, you do not want to splash any water because it could burn you.

Pour 1/4 cup of brown sugar into the lower half of the bottle. Carefully pour the brown sugar from the measuring cup into the lower half of the bottle. Try not to spill any over the edges. Set the measuring cup aside once you’ve emptied it.

Allow the mixture to cool. Set the bottle aside for however long it takes the hot water to cool. Twenty minutes should be long enough.

Add 1 gram of yeast to the plastic bottle. You don’t have to stir the mixture together. The yeast will consume the sugar and produce carbon dioxide, which attracts the mosquitoes.

Hold the top half of the bottle upside down. The lid of the bottle will be facing downwards at this point. While you are holding the top half of the bottle upside down, grab the bottom half with your other hand.

Place the top half upside down inside the bottom part of the bottle. Push the top inside gently until the cut edges align. Ensure the top of the bottle is above the water line. Adult mosquito should have enough room to fly in the bottle and down the lid. If there is not enough room for them to fly in the bottle, empty a bit of the solution out. Now, insects can fly into the trap and die from suffocation or starvation.

Secure the edges with tape. Use tape to keep the edges aligned. A few pieces of tape placed around the bottle will suffice to keep the edges in place.

Using the Mosquito Trap

Place the trap on a sturdy surface near the mosquitos. If there is a room or area where mosquitos have infested, place the trap there. A steady surface is optimal, such as a desk, counter, or the floor. Keep the trap out of people’s way so it won’t get knocked over.

Notice when the bottle is full of dead insects or is ineffective. Eventually, many mosquitos will die in the bottle, and you will have to clean the trap for it to be effective again. Even if there are not many mosquitos, the liquid in the trap eventually loses its effectiveness because all the yeast has finished eating the sugar and no longer attracts mosquitos; many sources say this takes two weeks. Use a calendar to keep track of when you will need to change the liquid. Change the liquid when the bottle is full of insects, even if two weeks have not passed.

Change the yeast and sugar solution when necessary. Luckily, this mosquito trap is reusable! Disassemble the trap by removing the tape. Then, wash both halves of the trap by rinsing it with water. Next, fill it up with more of the mosquito trap liquid.

What's your reaction?

Comments

https://rawisda.com/assets/images/user-avatar-s.jpg

0 comment

Write the first comment for this!