Place a hose clamp around the bike's handlebar with the screw fastener placed away from where your will have to rest your fingers.
Mark the vertical top point with a permanent marker.
Remove the clamp and drill a ⁄4 inch (0.6 cm) hole at the vertical top point.Smooth all rough edges.
Cut a section of old inner tube to fit under the clamp. Slide the ⁄4 inch (0.6 cm) screw through the hole you drilled and secure it with one of the lock washers and a wing nut.
Place the assembly on your handlebar, positioning it vertically with the inner tube underneath. Snug the hose clamp down over the inner tube section.
Place the other wing nut and lock washer on the screw upside own. Twirl it down a quarter inch to accommodate your camera's screw mount.
Put your camera on and twirl up the top wing nut to secure.
Comments
0 comment